MICR OPERATING PROCEDURES
MICR materials
Toner and developer
Turning MICR mode on or off
Turning MICR on/off through
Turning MICR on/off through
13-2
The 4635MX system is designed to meet ABA standards and ANSI
and ISO specifications for automatic check handling. It prints the
variable data and the MICR line at the same time.
Both the toner and the developer are designed to function on a
4635MX LPS and do not function satisfactorily in the 4635 or
4135 systems.
Fuser agent
Use only fuser agent in a 4635MX system.
The 4635MX LPS may run in MICR or non-MICR mode. This
gives you control of the printer MICR state. You can perform the
mode selection by entering commands either:
•
Through the Messages window of the PC UI
•
Through the system controller terminal
windows
1. Open Job Control Menu at the System UI.
2. Open MICR Mode Control Window.
3. Turn MICR on or off.
Figure 13-2.
Note: The MICR mode control window is only available if the
system has the MICR option installed.
command line
Enter the following command:
MICR [ON/OFF]
MICR mode control window
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE