Reviewing And Changing Data - Xerox 4635 Operator's Manual

METER READING AND REPORTING
A-10
Note: If you would like to practice with an imaginary serial
number before entering your actual serial number and meter
read, you can use serial number X12377889 (which converts to
*9212377889). This serial number is only a demonstration serial
number; it cannot generate a bill. You may practice all
procedures described in the "Entering meter read information"
section using this serial number.

Reviewing and changing data

1. To begin the review, enter **1#. The system reads the first
serial number.
2. To accept the serial number and continue, enter #. The
system then reads back the A meter read.
3. Continue the review by accepting with the # sign each time
the entry is read back correctly.
If an entry read back is incorrect, enter **4# to cancel the
entry, and reenter the correct information after the voice
prompts you to do so. Be sure to wait until the voice is
finished before making entries.
4. To end the review at any time, enter **2#. When the
review is ended, the system asks you to enter the # sign to
acknowledge the entries as complete. You may then choose
to enter more machine information or terminate the session.
(Refer to step 6 in the previous section.)
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE