Xerox 4635 Operator's Manual page 232

FILE CONTROL TASKS
Copy Labeled Tapes task through
10-8
command line • To copy files from labeled tape to system disk, enter the
following command:
COPY {TAPE|CART|TDn }[READ] LABEL [REVIEW] [disk-id]
{input-file-id [output-file-id|NEXT|ALL|file-type]}
TAPE [READ] LABEL
CART [READ] LABEL
TDn [READ] LABEL
REVIEW
disk-id
input file-id
output file-id
NEXT
ALL
file-type
• Use the following command to copy new files from system
disk to tape. The new files follow existing files on the tape.
If there are no existing files, the new files are written starting
at the beginning of the tape.
Note: If you are using either a new tape or writing over
existing files on a tape, you must use the VOLINIT command
before the COPY command. The VOLINIT command format
is as follows:
TAPE[TDn|CARTRIDGE]VOLINIT [,1600|6250]
TDn
The file(s) to be copied are on an LPS-
labeled tape.
The file(s) to be copied are on an 1/2
inch LPS-labeled cartridge tape device.
The file(s) to be copied are on the
specified tape device.
Displays a message when the file on
the tape will replace an existing file of
the same name on the disk and
requests whether to replace the file. If
you enter 'Y', the file on tape replaces
the disk file. If you enter 'N', the tape
skips to the next file. Enter 'X' to
abort the entire copy process.
Tells which disk (DP0:, DP1:, DP2:, or
DP3:) to which the file is to be written.
Keying in this parameter is not
necessary unless you want the file to
reside on a specific system disk.
Gives the name of the input tape file
to be copied to the system disk(s).
Use the following form: file-name.file-
type.
Provides the name to be given to the
output disk file, using the following
form: file-name.file-type. If no output
file id is specified, the file written to
the system disk has the same name as
the file tape.
The next file on the tape is to be
copied to the system disk.
Indicates that all the files on the tape
are to be copied to the system disk.
Specifies the name of a directory, such
as FRM, FNT, IMG, to be written to the
system disk.
The tape device containing the tape
you want to initialize.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE