Frequent Misfeeds (Processor Feeder Trays) - Xerox 4635 Operator's Manual

XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
6. For the processor feeder trays, relatch the paper feeder
assembly by pressing the green dot until the assembly clicks
into place.
Figure 12-30. Relatching the paper feeder assembly
7. Slide the tray back into the printer until the tray latches and
press the Continue button to resume printing.
8. Discard any pages sent to the sample tray, purge tray, or
unused stacker bin when the misfeed was detected.

Frequent misfeeds (processor feeder trays)

If the printer misfeeds frequently, the problem may be caused by
a glazed feed belt, especially if you notice that one tray feeds the
same paper better than another one does. (Glazing is caused by
a buildup of the chemicals found on most papers.)
If you suspect this is the problem, cleaning the feed belt may
eliminate the need to place a service call. Refer to the following
procedure.
PROBLEM SOLVING TASKS
12-23