Xerox 4635 Operator's Manual page 93

XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
SYSTEM RECOVERY FROM #### ABORT
PRINT ABORT DATA FOR LATER ANALYSIS Y/N?
2. Press <Y> for yes. PRINT REQUEST WILL BE QUEUED is
displayed. You are asked to verify date and time, and the
following messages are then displayed for online mode:
DO YOU WANT TO ATTEMPT AUTOMATIC JOB
RECOVERY? ('Y' OR 'N')
OS1061 INITIALIZING CSI
3. Press <Y> for yes. The system rollover causes the LPS to
go offline. After the system rollover, the following messages
are displayed:
OS0030 SYSTEM IS 'ONLINE'
OS2960 BACK UP HOST TO START OF REPORT
OR n PAGES, WHICHEVER IS LESS
OS2035 INPUT STOPPED.
HOST IS READY
4. The system automatically goes back online. Enter
CONTINUE I to resume printing. Any of the following
messages may be displayed, depending on the status of the
system before the system rollover:
OS0010 RESUMING INPUT
OS0020 RESUMING OUTPUT
OS1650 OUTPUT PROCESSING HAS CAUGHT UP WITH
INPUT PROCESSING
OS4650 INPUT HAS RECOVERED TO PAGE BOUNDARY
OS4651 OUTPUT HAS RECOVERED TO PAGE BOUNDARY
Note: Printed output to be given to the analyst is generated
after completion of the job in progress. It follows the
message:
OS1030 JOB #### HAS COMPLETED PRINTING
PERFORMING ABORT ANALYSIS DUMP
OS0040 SYSTEM IS OFFLINE
5. Enter the ONLINE (for online mode) and START commands
to resume normal operation.
SYSTEM CONTROL TASKS
ENTER 'CONTINUE I' WHEN
4-9