Operating Modes Of Sitrfc43 - Siemens SITRANS PCS 7 Function Manual

SITRANS FC430
12.1 SitrFC43
12.1.2

Operating modes of SitrFC43

Every HART auxiliary variable configured with PDM in the device has its own operating mode
switchover. The operating modes of the SitrFC43 block selectable in each case depend on
whether a totalizer or dosing value is configured for the respective HART auxiliary variable or
only a simple measured value.
Operating modes of SitrFC43 for simple measured value
The block can be operated using the following modes:
● On
● Out of service
"On"
You can find general information about the "On" mode in the "On" section.
"Out of service"
You can find general information about the "Out of service" mode in the Out of service section.
The descriptions of the operating modes are identical for SitrFC43 and the APL; refer to the
online help for the standard APL blocks for information on them.
Operating modes of SitrFC43 for totalizer or dosing value
The block can be operated using the following modes:
● Local mode
● Automatic mode
● Manual mode
● Out of service
The general descriptions of the operating modes are identical for SitrFC43 and the APL; refer
to the online help for the standard APL blocks for information on them.
The next section provides additional block-specific information relating to the general
descriptions.
466
Status bit Parameter
16 1 = At least one SV message is released
17 1 = At least one QV message is released
18 "Custody transfer mode" is active
19-23 Not used
24
BypassAct.Value
25 - 31 Not used
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11