Siemens SITRANS PCS 7 Function Manual page 176

SITRANS LUT400
6.1 Lut400
(3) Display of process value (4 to 20 mA signal) including signal status
This area indicates the current process value (4 to 20 mA signal) with the associated
signal status. The name of the configured measured value is displayed depending on
the PV_Meas0 variable, in this case "Fill level".
(4), (5), (6) and (7) Displaying the HART variables including signal status
This area provides information on the current process values of the HART variables with the
corresponding signal status. The name of the configured measured value is displayed
depending on the variables PV_Meas1..4, in this case "Distance", "Volume", "Flow" and
"Head".
(8) and (9) Display of auxiliary values
You can use this area to display two auxiliary values that have been configured in the
Engineering System (ES). You can find more information on this in the section "Opening
additional faceplates" in the APL Online Help.
(10) Button for switching to the standard view of any faceplate
Use this button for the standard view of a block configured in the Engineering System (ES). The
visibility of this navigation button depends on the configuration in the engineering system (ES).
You can find more information on this in the section "Opening additional faceplates" in the APL
Online Help.
(11) and (12) Display area for block states
This area provides additional information on the operating state of the block:
● "Simulation"
● "Maintenance"
(13) and (17) Limit display
These small colored triangles show you the limits set for fill level high or low alarm. If the fill level
is not configured as a 4 to 20 mA signal, no limits are displayed.
(14) Bar graph for the "Process value" (4 to 20 mA signal)
This area shows the current "Process value" (4 to 20 mA signal) in the form of a bar graph. The
visible area in the bar graph depends on the configuration in the engineering system (ES). (see
Display and operating range for process values and limits)
(15) Display of gradient (4 to 20 mA signal)
This display indicates whether the gradient is moving up (↑) or down (↓).
The gradient monitoring is displayed when the gradient value PV_Grad0 ≠ 0.
176
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11