Siemens SITRANS PCS 7 Function Manual page 405

(3) Switching between the two faceplate views
Display of the limits is divided between two faceplate views. It is possible to toggle between the
two views here.
(4) Enabled operations
This area shows all operations for which special operator authorizations are assigned. They
depend on the configuration in the engineering system (ES) that applies to this block.
Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: The OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator authorizations (OS_Perm or OS1Perm)
(6) Gradient limits
You can enter gradient limits in this area. Refer to the "Changing values" section in the APL
online Help.
You can change the following limits:
● "H alarm ⇑": Gradient for the upper gradient for positive changes
● "H alarm ⇓": Gradient for the upper rate of rise for negative changes
● "L alarm ⇑⇓": Gradient for the lower rate of rise (absolute)
(7) Message suppression/delays
The message suppression indicates whether suppression of the associated message is
activated in the AS block using the xx_MsgEn parameter. The output of messages is not
suppressed when the block is installed (all xx_MsgEn parameters are set to 1 by default).
Messages can only be output if limit monitoring of the additional analog value has been enabled.
Alarm delays are also displayed in this state; refer to the "Application of alarm delays" section
in the APL Online Help.
(8) Suppress messages
You can activate/deactivate messages by selecting the check mark.
See also
Views of SitransP (Page 399)
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
SITRANS P
10.1 SitransP
405