Siemens SITRANS PCS 7 Function Manual page 515

The following operating modes can be shown here:
● On (see the APL online help)
● Out of service (see APL Online Help)
With totalizer:
The block can be operated using the following modes:
● Local mode
● Automatic mode
● Manual mode
● Out of service
(4) Display of process value (TV) including signal status
This area indicates the current process value (TV) with the associated signal status. The name
of the configured measured value is displayed depending on the PV_Meas2 variable, in this
case "Mass flow".
(5) Display and switchover of operating mode QV
This area provides information on the currently valid operating mode. The operating mode
switchover depends on whether or not a totalizer is configured.
The following operating modes can be shown here:
Without totalizer:
The following operating modes can be shown here:
● On (see the APL online help)
● Out of service (see APL Online Help)
With totalizer:
The block can be operated using the following modes:
● Local mode
● Automatic mode
● Manual mode
● Out of service
(6) Display and change the totalizer command QV: Positive and negative, positive, negative and hold
This area shows you the default operating state for the totalizer QV. The following states can
be shown and executed here:
● "Positive and negative"
● "Positive"
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
SITRANS FC430
12.1 SitrFC43
515