Siemens SITRANS PCS 7 Function Manual page 760

MultiRanger 200
16.1 MR200
Figure 16-3 Limit view Mr200 relay and PCS 7 messages
(1) Process value (PV1, PV2 and PV3) limits
In this area, you can enter the limits for process values (PV1, PV2 and PV3). This device also
supports relay "On Setpoint" and "Off Setpoint" limits. You can change the following limits:
● "H alarm": High alarm
● "H warning": High warning
● "Hysteresis"
● "L warning": Low warning
● "L alarm": Low alarm
When a relay is configured as an alarm or warning limit you can change the below limits:
(Refer the figure Limit view for Mr200 with relay)
● "H alarm On": High alarm for relay "On Setpoint"
● "H alarm Off": High alarm for relay "Off Setpoint"
● "H warning On": High warning for relay "On Setpoint"
760
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11