Slave Pointer View Of Sitranst - Siemens SITRANS PCS 7 Function Manual

(3) Enabled operations
This area shows all operations for which special operator authorizations are assigned. They
depend on the configuration in the engineering system (ES) that applies to this block.
Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: The OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator permissions (OS_Perm or OS1Perm)
The following enabled operationss are shown here:
General operator input enables for totalizers and dosing units:
● "On": You can switch to "On" mode.
● "Out of service": You can switch to "Out of service" mode.
"Local operator authorization": Use the ← button to change to the standard view of the
OpStations block. For more information, refer to the "Operator authorizations" section in the
APL Online Help.
See also
Views of SitransT (Page 350)
9.1.9.6

Slave pointer view of SitransT

Slave pointer view of TH300
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
SITRANS T
9.1 SitransT
357