Siemens SITRANS PCS 7 Function Manual page 684

SITRANS LR HART
15.1 SitrLRHA
Configurable reactions using the Feature I/O
The following response features are available for this block at the respective bits of
the Feature connection. If a description is not available here, it can be referenced in the APL
Online Help.
0
1
2
6
8
20
22
24
25
26
28
29
For more information about the feature bits please refer to the APL online help.
Operator authorizations
This block provides the standard operating permissions that are described in the APL online
help.
The block has the following permissions for the OS_Perm parameter:
Bit
0
1
2
3
4 - 5
6
7
8
9
10
11
12
13
14
15
16
17
684
Bit Feature
Setting the startup characteristics
Reaction to the Out of service mode
1 = HART communication present between module and controller
1 = Activate calculation of fill time/empty time
Separate delay times for each alarm (Page 52)
Substitution value is active if the block is in bypass
Update acknowledgment and error status of the message call
Enable local operator authorization
Suppress all messages
Reaction of the switching points in "Out of service" mode
Disabling switching points
Signaling limit violation
Function
Not used
1 = Operator can switch to "On" mode
Not used
1 = Operator can switch to "Out of service" mode
Not used
1 = Operator can change simulation values
1 = Operator can reset the maximum values
1 = Operator can activate / deactivate messages with GradHUpMsgEn
1 = Operator can activate / deactivate messages with GradHDnMsgEn
1 = Operator can activate / deactivate messages with GradLMsgEn
1 = Operator can enable the Simulation function
1 = Operator can activate the Release for maintenance function
1 = Operator can change the limit (PV_In) for the high alarm
1 = Operator can change the limit (PV_In) for the high warning
Not used
1 = Operator can change the limit (PV_In) for the hysteresis
1 = Operator can change the limit (PV_In) for the low alarm
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11