Siemens SITRANS PCS 7 Function Manual page 352

SITRANS T
9.1 SitransT
(2) High and low scale range for the process value (4 to 20 mA signal)
These values provide information on the display range for the bar graph of the process value
(4 to 20 mA signal). The scale range is set in the engineering system with the PV_OpScale
parameter, see Display and operating range for process values and limits.
(3) Display of process value (4 to 20 mA signal) including signal status
This area indicates the current process value (4 to 20 mA signal) with the associated signal
status. The name of the configured measured value is displayed depending on the PV_Meas0
variable, in the case of TH300 "Resistence" and in the case of TH420 "Input1". You can refer
the I/Os section for possible measurement values of 4..20mA signal and the HART variables
that can be visualized in the faceplate for TH420 device
(4), (5), (6) and (7) Display of HART variables including signal status
This area provides information on the current process values of the HART variables with the
corresponding signal status. The name of the configured measured value is displayed
depending on the PV_Meas1..4 variable, in this case "Resistence", "Diff. resistance", "Not
used", and "Electronics temperature".
(8) and (9) Display of auxiliary values
You can use this area to display two auxiliary values that have been configured in the
Engineering System (ES). You can find more information on this in the section "Opening
additional faceplates" in the APL Online Help.
(10) Button for switching to the standard view of any faceplate
Use this button for the standard view of a block configured in the Engineering System (ES). The
visibility of this navigation button depends on the configuration in the engineering system (ES).
You can find more information on this in the section "Opening additional faceplates" in the APL
Online Help.
(11), (12) and (13) Display area for block states
This area provides additional information on the operating state of the block:
● "Wrong device"
● "Simulation"
● "Maintenance"
(15) Display of gradient (4 to 20 mA signal)
This display indicates whether the gradient is moving up (↑) or down (↓) .
The gradient monitoring is displayed when the gradient value PV_Grad0 ≠ 0 .
352
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11