Siemens SITRANS PCS 7 Function Manual page 455

Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: the OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator permissions (OS_Perm or OS1Perm)
The following enabled operationss are shown here:
General enabled operationss:
● "Automatic": You can switch to "automatic mode".
● "Manual": You can switch to "manual mode".
● "Local": You can switch to "local mode".
● "Out of service": You can switch to "Out of service" mode.
Totalizer:
● "Start Pos./Neg": You can start the totalizer in positive and negative mode.
● "Start positive": You can start the totalizer in positive mode.
● "Start negative": You can start the totalizer in negative mode.
● "Hold": You can stop the totalizer.
● "Reset": You can reset the totalizer.
Other:
● "Read temperature": You can read the sensor and electronics temperature.
"Local operator authorization": Use the button to change to the standard view of the
OpStations block. For more information, refer to the "Operator authorizations" section in the
APL Online Help.
(6) Display current control signals
This area shows the most important parameters for this block with the current selection:
● "Local Tot": 1 = Totalizer is operated in "Local mode"
● "Local P./N. Tot": 1 = Totalizer counts positive and negative in "Local mode"
● "Local Pos. Tot": 1 = Totalizer counts positive in "Local mode"
● "Local Neg. Tot": 1 = Totalizer counts negative in "Local mode"
● "Local Neg. Hold": 1 = Totalizer is in hold in "Local mode"
(7) Button for switching to the standard view of any faceplate
Use this navigation button to open the standard view of a block configured in the engineering
system. The visibility of this navigation button depends on the configuration in the engineering
system (ES).
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
SITRANS P PA
11.1 SitrP_PA
455