Siemens SITRANS PCS 7 Function Manual page 238

SIPART PS2 HART
7.1 SipPS2HA
The following is displayed in addition to the buttons:
● Interlock status (see "Forming the group status for interlock information" section in the APL
Online Help), for example:
● Signal status (see "Form and output signal status for technological blocks" section in the
APL Online Help), for example:
● Bypass information:
If there is a bypass, it is displayed instead of the signal status.
(13) Display of auxiliary values
This display is only visible when the corresponding block input is connected.
You can use this area to display two auxiliary values that have been configured in the
Engineering System (ES). For more information, refer to the "Displaying auxiliary values"
section in the APL Online Help.
(14) Button for switching to the standard view of any faceplate
This display is only visible when the corresponding block input is connected.
Use this button for the standard view of a block configured in the Engineering System (ES). The
visibility of this navigation button depends on the configuration in the engineering system (ES).
Refer to the "Calling further faceplates" section in the APL Online Help.
(15) Display area for block states
This area provides additional information on the operating state of the block:
● "Maintenance"
(16) Display area for block states
This area provides additional information on the operating state of the block:
● "Simulation"
For more information, refer to the "Simulating signals" section in the APL Online Help.
● "Time delay"
Time delay provides information that timer is running.
238
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11