Parameter View Of Sitrp_Pa - Siemens SITRANS PCS 7 Function Manual

SITRANS P PA
11.1 SitrP_PA
(5) Message suppression/delays
The message suppression indicates whether suppression of the associated message is
activated in the AS block using the xx_MsgEn parameter. The output of messages is not
suppressed when the block is installed (all xx_MsgEn parameters are set to 1 by default).
Messages can only be output if limit monitoring of the additional analog value has been enabled.
Alarm delays are also displayed in this state; refer to the "Application of alarm delays" section
in the APL Online Help.
(6) Suppress messages
You can activate/deactivate messages by selecting the check mark.
11.1.8.4

Parameter view of SitrP_PA

(1) Reading the configuration data
In this area, you can read all configuration data relevant to the block from Sitrans P.
(2) Writing the configuration data
In this area, you can write all relevant configuration data, i.e. limits, to the Sitrans P.
452
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11