Siemens SITRANS PCS 7 Function Manual page 402

SITRANS P
10.1 SitransP
(11) and (12) Display of auxiliary values
You can use this area to display two auxiliary values that have been configured in the
Engineering System (ES). You can find more information on this in the section "Opening
additional faceplates" in the APL Online Help.
(13) Navigation button to the standard view of any faceplate
Use this button for the standard view of a block configured in the Engineering System (ES). The
visibility of this navigation button depends on the configuration in the engineering system (ES).
You can find more information on this in the section "Opening additional faceplates" in the APL
Online Help.
(14), (15) and (16) Display area for block states
This area provides additional information on the operating state of the block:
● "Maintenance"
● "Simulation"
● "Wrong device"
(17) Limit display
These small, colored triangles indicate the specified limits in the respective bar graph. They are
only visible if the 4 to 20 mA signal is monitored by a limiter.
(18) Bar graph for the "Process value" (4 to 20 mA signal)
This area shows the current "Process value" (4 to 20 mA signal) in the form of a bar graph. The
visible area in the bar graph depends on the configuration in the engineering system (ES), see
Display and operating range for process values and limits.
(19) Display of gradient (4 to 20 mA signal)
This display indicates whether the gradient is moving up (↑ or down↓).
The gradient monitoring is displayed when the gradient value PV_Grad0 ≠ 0.
(20) Bar graph for the gradient (4 to 20 mA signal)
This area shows the current gradient value in the form of a bar graph. The visible area in the bar
graph depends on the configuration in the engineering system (ES), see Display and operating
range for process values and limits.
See also
Views of SitransP (Page 399)
402
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11