Siemens SITRANS PCS 7 Function Manual page 524

SITRANS FC430
12.1 SitrFC43
Note
The following screenshots show a sample configuration for SV (dosing), TV (measured value)
and QV (totalizer). The structure of the faceplate is always based on the individual configuration
in PDM.
(1) Process value PV
This area displays the real process values PV.
(2) Automatic preview SV
This area shows you the dosing or totalizer command that is input after a switch from "manual
mode" to "automatic mode".
If the block is in "automatic mode", the current dosing or totalizer command is displayed.
If a dosing unit or totalizer is not configured, the area is switched to invisible.
(3) Bypass
This area shows the Bypass values.
(4) Enabled operations PV
This area shows the operations for the process value PV for which special operating
permissions are assigned. They depend on the configuration in the engineering system (ES)
that applies to this block.
Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: the OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator permissions (OS_Perm or OS1Perm)
The following enabled operationss are shown here:
● Reset: You can reset the peak value of the gradient.
● "On": You can switch to "On" mode.
● "Out of service": You can switch to "Out of service" mode.
(5) Enabled operations SV
This area shows the operations for the process value SV for which special operating
permissions are assigned. They depend on the configuration in the engineering system (ES)
that applies to this block.
524
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11