Siemens SITRANS PCS 7 Function Manual page 522

SITRANS FC430
12.1 SitrFC43
(3) Zero adjustment
The zero balancing in the FC430 is triggered here.
(4), (6) and (8) Totalizer preset value
In this area, you specify a preset value for the totalizer.
If a totalizer is not configured, the area is switched to invisible.
(5), (7) and (9) Set totalizer preset value
In this area, you can set the totalizers to the preset value with the click of a button.
If a totalizer is not configured, the area is switched to invisible.
(10) and (11) Low flow cut-off suppression
The low flow cut-off suppression for mass and volume flows is displayed in this area.
(12), (13) and (14) Service
You can select the following functions in this area:
● "Bypass"
● "Simulation"
● "Release for maintenance"
For more information about this area, refer to the following sections of the APL Online Help:
● Bypassing signals
● Simulating signals
● Release for maintenance
(15) Password
A password must be entered before message limits can be changed in the device when writing
all configuration data; this is entered here.
(16) Enabled operations
This area shows all operations for which special operator authorizations are assigned. They
depend on the configuration in the engineering system (ES) that applies to this block.
522
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11