Siemens SITRANS PCS 7 Function Manual page 240

SIPART PS2 HART
7.1 SipPS2HA
(22) Display area for state of the binary input BE1
This area provides additional information on the binary input BE1 according to the configuration
of Bin1:
● "Message Bin1"
● "Configuration change blocked"
● "Configuration change blocked/Manual mode"
● "Travel to end value"
● "Travel to start value"
● "Movement blocked"
● "PST" (Partial-Stroke-Test)
(23) Display area for block states
This area provides additional information on the operating state of the block:
● "Limit violated"
(24) Display area for block states
This area provides additional information on the operating state of the block:
● Wrong Device
(25) Display area for state of the Sipart PS2 HART
This area provides additional information on the Sipart PS2 module:
● "Stroke integral exceeded"
(26) Automatic preview
This display is only visible in "manual mode", in "local mode", or with a reset request in
"automatic mode", when the current output signals are not identical to the control in "automatic
mode".
The display shows what state the valve would assume if you switched from "manual" or "local"
mode to "automatic mode", or performed a reset to "automatic mode".
(27) Status display of the control valve
You can find additional information on this in section SipPS2HA block icon (Page 249).
See also
Views of SipPS2HA (Page 234)
240
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11