Installing The Projector Lens - Christie Mirage SST Installation And Setup Manual

2. Once the required adjustment is made, using a wrench, tighten the lock nut against the
bottom of the projector.

Installing the projector lens

Only use lenses designed for Mirage SST projectors. Installing a lens not designed for Mirage SST,
results in a warning that the lens is not present.
1. Turn off the lasers.
2. Remove the lens caps from the lens.
The packaging tape is required to ensure safe shipment of the projection lens to restrain the
zoom ring from rotating during shipping.
3. Align the guides on the front cover and the lens marked by a red line.
4. Insert the lens into the projector and turn it clockwise until you hear two clicks.
The first click indicates the safety lock mechanism has been engaged.
5. Continue to turn the lens clockwise until you hear a second click.
The second click indicates the lens is fully locked in position. The top center label should face
up and be aligned to the lens guide on the front cover.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
27