Installing The Lens - Christie CP2309-RGB Installation And Setup Manual

5. Connect the UPS input plug to the IN-LINE receptacle connector.
A MAIN input plug
B IN-LINE receptacle
C UPS input plug
6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Re-install the rear cover of the projector.
8. Re-install the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, make sure you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when installing or transport
the projector.
1. Remove the lens surround.
2. On the front of the projector, unlock the lens assembly with a hex key.
CP2309-RGB Installation and Setup Guide
020-103078-04 Rev. 1 (11-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
21