Connecting Sources - Christie Roadie HD+35K User Manual

Refer to Section 6 Specifications.
1. Check lamp cradle (Anode end) location for your
lamp.
• For 4.5 or 6.0 kW lamps, the lamp cradle should use
the holes farthest from the reflector (factory
default).
• For 2.0 or 3.0 kW lamps, use the holes closest to the
reflector.
2. Install lamp.
Refer to Section 4.4 Replacing the Lamp &
Steps 7-11 for installation instructions.
NOTES: 1)
Observe all warnings, and wear protective
clothing and shielding.
mark the "Lamp Installed" label on the lamp door
to indicate current lamp size.
Liquid Cooling
During operation, a closed loop of flexible tubing
circulates liquid coolant from a small reservoir to critical
electronic components located near the front of the
projection head. The coolant (a 50/50 mix of distilled
water and ethylene glycol) should fill slightly more than
half of the reservoir to ensure adequate circulation. The reservoir, which is located in the Igniter compartment,
is factory-filled and does not require draining for transit. Check regularly.
2.5

Connecting Sources

Sources connect to the Input Panel located on side of the projector closest to the lens. Refer to
The upper left corner (INPUT 1) typically accepts an RGB signal from an external analog RGB source, or it
can also be used for YPbPr signals. Just beneath these BNCs, the DVI-I connector (INPUT 2) accepts digital
or analog display signals from a computer. An HDMI to DVI adapter cable accepts digital signals from a Blu-
Ray or DVD player. Connect analog composite video at INPUT 3 or S-video at INPUT 4 from devices such as
VCRs or DVD players. At INPUT 5 , connect serial digital YCbCr (4:2:2) or compatible SMPTE signals (note
this module can be moved to INPUT 6. if desired).
There are also several optional interfaces available for connecting other sources, these interfaces slide into
either Input 5 or Input 6, and can be removed or installed while the projector is running.
NOTE:
Some Input options are not available with some projector models.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Filter,
2)
Do Not forget to properly
Section 2: Installation and Setup
Anode
Connector
Figure 2-26 Move cradle back for 2.0 or 3.0
Reflector
Lamp
Cradle
Figure 2-27.
2-23