Liquid Cooling; Ventilation; Connecting Sources - Christie Roadie HD+35K Setup Manual

Section 2: Installation and Setup
See Section 5 Specifications.
1. Check lamp cradle (Anode end) location for your lamp.
• For 4.5 or 6.0 kW lamps, the lamp cradle should use the
holes farthest from the reflector (factory default).
• For 2.0 or 3.0 kW lamps, use the holes closest to the
reflector.
2. Install lamp.
See Section 4.2 Replacing the Lamp and Filter in the
Roadie HD+35K User Manual.
NOTES: 1) Observe all warnings, and wear protective
clothing and shielding. 2) Do Not forget to properly mark
the "Lamp Installed" label on the lamp door to indicate
current lamp size.

2.4.3 Liquid Cooling

During operation, a closed loop of flexible tubing circulates
liquid coolant from a small reservoir to critical electronic
components located near the front of the projection head. The
coolant (a 50/50 mix of distilled water and ethylene glycol)
should fill approximately half of the reservoir to ensure
adequate circulation. The reservoir, which is located in the Igniter compartment, is factory-filled and does not
require draining for transit. Check regularly.

2.4.4 Ventilation

Vents and louvers in the projector covers provide ventilation, both for intake and exhaust. Never block or cover
these openings. Do not install the projector near a radiator or heat register, or within an enclosure.
2.5

Connecting Sources

Sources connect to the Input Panel located on side of the projector closest to the lens. See
The upper left corner (INPUT 1) typically accepts an RGB signal from an external analog RGB source, or it
can also be used for YPbPr signals. Just beneath these BNCs, the DVI-I connector (INPUT 2) accepts digital
or analog display signals from a computer. An HDMI to DVI adapter cable accepts digital signals from a Blu-
Ray or DVD player. Connect analog composite video at INPUT 3 or S-video at INPUT 4 from devices such as
VCRs or DVD players. At INPUT 5, connect serial digital YCbCr (4:2:2) or compatible SMPTE signals (note
this module can be moved to INPUT 6. if desired).
There are also several optional interfaces available for connecting other sources, these interfaces slide into
either Input 5 or Input 6, and can be removed or installed while the projector is running.
NOTE: Some Input options are not available with some projector models.
2-16
Figure 2-11 Move cradle back for 2.0 or 3.0
Roadie HD+35K Setup Guide
Figure 2-12.
020-100394-06 Rev. 1 (10-2013)