Connecting Sources Through Option Cards; Leds; Twin Hdmi Input Card - Christie Mirage M Series User Manual

Connecting sources through option cards

Sources are connected to the input panel located at the back of the projector. The Input Panel
allows one image processor board and up to four input cards to be inserted. The input cards are hot
swappable, meaning they may be plugged in and out while the projector is active. The image
processor should only be replaced when the projector is off or when it is in standby mode.
Seven option input cards are available:
• High-Definition Multimedia Interface/Twin HDMI (High-Definition Multimedia interface)
• Analog BNC
• Dual 3G/HD/SD-SDI (Serial Digital interface)
• Dual Link DVI
• Video Decoder
• DMX512 interface
• Twin Display Port
These cards slide into the option slots located at the rear of the projector and can be used in any
slot. One or more of the option slots may be used with any combination of option cards, including
multiples of the same card type. There may be up to two active inputs displayed at any time, either
from one card or from two cards. These two inputs can be routed to outputs or to the main or PIP
video image.

LEDs

LEDs are located on the faceplate of each input card and indicate the following:
• Power ON —Green
• Signal Valid—Green
• Signal Invalid—OFF

Twin HDMI input card

This card accepts one or two HDMI inputs and can route one or both inputs to the card's outputs.
Any input from any card can be looped out of this card. The output label 1-OUT loops out the main
image being displayed on the projector. The output labelled 2-OUT loops out the image displayed in
the picture in picture (PIP). Any input from any optional input card can be looped out of this card.
There are five LEDs on the module faceplate. The PWR on the left side indicates power is applied
and the card is initialized. The LEDs to the right side of the corresponding connectors indicate that
a valid signal is detected. In the case of the output, the LED indicates a signal is currently being
looped out.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Installation and Setup
44