Usb Connector; Ir Connector; Connector; Relay Connector - Lightware HDMI-TPS-RX110AY Series User Manual


  
2. Installation
2.2.5. USB Connector
The extender provides standard USB 2.0 mini B-type connector for software control purpose.
2.2.6. IR Connector
IR detector and IR emitter can be connected to the receiver with TRS (Tip, Ring, and Sleeve) connectors.
Theyarealsoknownas(3,5mmorapprox.1/8")audiojack,phonejack,phoneplug,andmini-jack
plug.Thepinassignmentsarethefollowingforthedetectorandtheemitter:
1 2 3
Detector – 3-pole TRS
1 Tip Signal (active low)
2 Ring GND
3 Sleeve +5V

INFO: Ring pole of the emitter is optional. If your IR emitter has three-pole TRS plug, then the Ring and the
Sleeve are the same signal (Output - ).
YoucanfindmoreinformationaboutInfraredinterfaceintheIR Interface
2.2.7. RS-232 Connector
The receiver contains a 3-pole Phoenix connector which is used for RS-232 serial connection.
1 2 3
RS-232 connector pin assignments
Compatible Plug Type
Phoenix Combiconseries(3.5mmpitch,3-pole),type:MC1.5/3-ST-3.5.
®
YoucanfindmoreinformationaboutRS-232interfaceintheSerial Interface
1 2-3
Emitter – 2-pole TS
1 Tip +5V
2 Ring
Signal (active low)
3 Sleeve
section.
Pin nr. Signal
1 Ground
2 TX data
3 RX data
section.
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
HDMI-TPS-RX110AYseries–User'sManual
2.2.8. Relay Connector
Thereceivercontainsa4-polePhoenixconnectorwhichisusedforrelayconnection.

INFO: Themaximumratingsforeachrelayare30Vand1A,AC/DC.
Compatible Plug Type
Phoenix Combiconseries(3.5mmpitch,4-pole),type:MC1.5/4-ST-3.5.
®
YoucanfindmoreinformationaboutrelayinterfaceintheRelay Interface
Pin nr. Signal
1 Pin 1 for Relay 1
2 Pin 2 for Relay 1
3 Pin 1 for Relay 2
4 Pin 2 for Relay 2
Relay connector pin assignment
section.
14