Edit Entries - Control Data Corporation CYBER 170 Series Operator's Manual

)
)
I
/'
)
EDIT ENTRIES '
After you have made all the entries, you are given the
opportunity to change any of the responses. By entering
the number which now precedes each line that has an entry,
that line is blanked and any subsequent lines which depend
on that line are removed from the display. Those choices
are then presented again.
To add a comment to an eritry, type
CYB, comment.
The maximum length of the comment, excluding CYB, and
the period, is 35 characters. The system inserts the word
COMMENT on the display before the comment 'as shown in
figure 2-35.
Figure 2-35 illustrates a sample display showing a
completed CYBERLOG entry.
After completing edit entries, enter NEXT or END to
transfer the data to the error log dayfile. If you enter
NEXT, the CYBERLOG program transfers the data to the
error log dayfile and restarts from the beginning to allow a
different event to be recorded. With END, after the
message is written to the error log dayfile, the CYBERLOG
program terminates.
CYBERLOG
0 EVENT TYPE: UNSCHEDULED
60435600 J
1 REASON: HARDWARE
~
COMPONENT:
DISK SUBSYSTEM
3 ELAPSED TIME: 03.15
4
LOST TIME: 03.15
5 IMPACT:
DEGRADED
COMMENT CYB, THIS IS A SAMPLE COMMENT LINE.
TO CHANGE ANY LINE, ENTER THE LINE NUMBER
TO WRITE CURRENT MESSAGE AND REPEAT FOR NEW MESSAGE,
ENTER IINEXT II
TO. EXIT, ENTER END
TO WRITE A COMMENT, ENTER *CYB,* FOLLOWED BY NO MORE
THAN 35 CHARACTERS, TERMINATED BY' A PERIOD.
Figure 2-35. Sample Completed CYBERLOG Entry
2-33