Control Data Corporation CYBER 170 Series Operator's Manual page 231

,,-/
C)
Q
~
W
tTl
C)
Q
Q
t"'I
~
~
"' - -
"----./
MESSAGE
MESSAGE STATUS TABLE OVERFLOW.
MID CURRENTLY ACTIVE.
MID NOT SPECIFIED.
MID SPECIFIED NOT DOWN.
MID SPECIFIED NOT FOUND.
MID UNDEFINED IN ECS'.
MISSING AlP ENTRY POINT.
MISSING CARTRIDGE.
filenam FOR jobnam NOT FOUND ON MSS.
~USSING HEADER WORD ON xxJ FILE.
MMF DEVICE ACCESS ERROR.
"-.--'
"--/
SIGNIFICANCE
Space sufficient to allocate the required
table was not available. An internal change
to IAF is necessary.
ECS resident indicates that the machine ID
specified in the CMRDECK is in use by
another mainframe. Operator message.
Recovery is impossible.
K-display message indicating that the
machine ID of the machine on which to per-
form recovery processing was not entered.
K-display message indicating that the ma-
chine with the specified machine ID was not
determined to be down.
K-display message indicating that the ma-
chine with the specified machine ID was
not found in the multimainframe complex.
CPUMTR preset routine failed to find a
copy of low core MMFL word in ECS resident.
This message implies that machine ID has
changed and/or MMFL link tables have been
destroyed. Operator message. Recovery
is impossible.
No entry point for a required AlP
subroutine was returned by the loader.
The staging of file filenam for job jobnam
was abandoned because a cartridge was
missing.
The first statement on the xxJ file is in
error, causing the transaction subsystem to
abort.
Verification of this machine's access to a
given mass storage device failed during a
level 3 recovery. Possible causes are the
following.
The CMR copy of the MST has been
destroyed (specifically, the DAT index
ACTION
Inform site analyst.
Change machine ID.
Enter ~achine ID and type
K.GO.
Correct machine ID and
reenter or type K.STOP.
Correct machine ID and
reenter.
Change machine ID or
perform a level 0
deadstart.
Inform site analyst.
When the cartridge is
located, a site analyst
should run ASLABEL to
restore it to its proper
cubicle. (Refer to
section 3 of the NOS
System Maintenance
Reference Manual.)
Examine xxJ files for
header xxJ. Consult the
TAF data base
administrator.
Perform a level 0
deadstart.
'-
ROUTINE
IAFEX
CPUMTR,
RMS
MREC
MREC
MREC
CPUMTR,
RMS
IAFEX
EXSTGE
TAF
RMS
~