Control Data Corporation CYBER 170 Series Operator's Manual page 266

Nos version 1
Table of Contents

Advertisement

tp
co
N
0)
o
"' "
CA)
CJ1
CJ)
o
o
t"'
MESSAGE
TASK LIBRARY DIRECTORY ERROR - libnam.
TASK LIBRARY DIRECTORY TOO LONG - libnam.
TASK NOT VALIDATED FOR REQUEST.
TCR I/O FATAL ERROR.
TELEX ABNORMAL - xxx,nnnnnn.
TELEX BUSY.
TELEX INITIALIZATION ABORT.
TELEX TERMINATE.
SIGNIFICANCE
Task library libnam contains no recognizable
directory.
TAF aborts.
The directory record on task library libnam
exceeded the maximum length allowed by the
transaction executive (170 files).
TAF
aborts.
.
One of the following actions has occurred.
The terminal operator initiated a
transaction which tried to perform an
action associated with a data base for
which the terminal was not validated.
A NEWTRAN request was issued by a task
not in the system task library
(TASKLIB).
NVF cannot initialize the TCR file.
NVF
aborts.
Informative message indicating that TELEX
has encountered an abnormal situation.
If
sense switch
3
is set, TELEX attempts to
enter active users into the recovery state,
abort, and then reload automatically.
xxx
TELEX routine requesting the
abort
nnnnnn
Contents of the B2 register
(usually contains a terminal
number)
K-display message indicating an attempt
to send a request to the time-sharing
executive was denied.
TELEX could not be· initialized properly.
An additional dayfile message describing
the error in.more detail should precede
this message.
ACTION
Inform site analyst.
Task library must be
corrected.
Inform site analyst.
Size of task library
libnam must be reduced
and TAF reassembled.
Perfor;m the appropriate.
action.
Inform site analyst;
transaction must be
reinitialized.
Set
up the terminal name
in the network file
to use the data
base.
The system
data base (SY) may
be used.
-
Put the task on
TASKLIB.
Inform site analyst.
None.
Retry operation.
Restart TELEX using DSD
command TELEX (refer to
section
3).
Informative message indicating that TELEX
None.
was stopped and was not restarted.
This
message is issued when TELEX is dropped (via
1.STOP. command).
ROUTINE
TAF
TAF
MSABT
NVF
I
TELEX
TAF
TELEX
TELEX

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents