Control Data Corporation CYBER 170 Series Operator's Manual page 267

en
o
"' "
t.)
c.n
0)
o
o
t"'
"-
/
tp
CO
t.)
-
\
"--
. MESSAGE
TERM. name,status,dt/tc,caddr/taddr,appl
TERMINAL termid Ccc Ee Pp MALFUNCTION.
TERMINAL termid Ccc Ee Pp UP.
TERMINAL nnn. JOB LOST.
TERMINAL TABLE OVERFLOW.
TERMINALS MISSING IN NETWORK FILE.
~/
"- j
SIGNIFICANCE
Terminal status message sent in response to
a STATUS command, or when a significant
change in status has occurred.
name Name of terminal
status Status of terminal
DI Disabled
EN Enabled
AC Active
DN Down
dt Device type
tc Terminal class
caddr Cluster address. Refer to the
Network Definition Language
Reference Manual. .
taddr Terminal address (for HASP
multileaving terminals, this is
the stream number)
appl Name of application to which
terminal is connected
Terminal failed to answer poll.
termid Terminal identifier
cc Multiplexer channel number
e Equipment number
p Port number
Terminal is operative after previously
failing to answer.
termid Terminal identifier
cc MUltiplexer channel number
e Equipment number
p Port number
Informative message indicating that an
abnormal situation has occurred during
time-sharing subsystem recovery. An attempt
is made to terminate a job from the system
because the active user logged in at
terminal nnn cannot locate the job.
Recovery continues, but that user will be
unable to recover.
Space sufficient to allocate the required
table was not available. An internal change
to the time-sharing executive is necessary.
A valid network file was found but no trans-
action terminals wer·e defined in it. If TAF
interfacing with TELEX is being used, TELEX
was not reinitialized to recognize the same
network file that TAF was using.
ACTION
No action required
unless the disabling of
an enabled, active, or
down terminal, or the
enabling of a disabled
terminal is desired.
Inform customer
engineer. This message
may be indicative of
hardware failure.
Inform customer
engineer. This message
may be indicative of
hardware failure.
None.
Inform site analyst.
Ensure that the network
file is under the proper
name; if it is, inform
site analyst. If TAF
interfacing with NAM is
\~
ROUTINE
CS
TAF
TAF
IAFEX,
TELEX
IAFEX,
TELEX
TAF
"