Control Data Corporation CYBER 170 Series Operator's Manual page 41

Option
I
./
)
I
60435600 L
Description
I
NOTE
I
There is no capability in the
deadstart dump interpreter
(DSD!) to translate
control ware dumps.
Whenever EDD is waiting for input, the dump
can be stopped by entering the character
S~
The console displays:
DUMP id STOPPED
id 'Dump identifier.
When the dump is complete, the console
displays:
DUMP id COMPLETE
id Dump identifier.
Activate the deadstart switch. The initial
options (* A *) display reappears and additional
options can be selected.
Install CTI on RMS. Select this option to load
the CTI module onto an 885 or 844 mass
storage device or to release space occupied
by the CTI module on an 885 or 844 mass
storage device. The console displays as
shown in figure 2-24.
I
NOTE
I
When installing CTI for the
first time on a disk, select the
R option first to ensure that
the reserved disk space has
been released and the disk is
properly prepared. This will
also release the space reserved
for DDS or MSL.
Option
ENTER ONE OF THE FOLLOWING
Description
If you press CR, the following warning
message appears.
*WARNING*
PERMANENT FILES MAY BE LOST
IF DISK DEADSTART MODULE NOT
INSTALLED ON DEVICE
(CR) TO CONTINUE
Before proceeding to the next step, be
I
certain that the disk to which you will load
CTI does not contain any permanent files or
information that must be preserved, unless
you are just replaCing an existing copy of CTI
with another.
Press CR to continue.
After you select CR or R, the system then
asks for the channel, equipment, and unit
numbers for the device CTI is to be loaded on
or released from. Use the same procedure to
enter these digits as shown in the description
of the S option (alternate device deadstart)
earlier in this section.
The display header will be either one of. the
following.
INSTALL DISK DEADSTART MODULE
RELEASE CMSE-RESERVED DISK SPACE
Once you have specified a device, the system
attempts to read the deadstart sector from
the device. If the specified device is
inaccessible, the system displays the
following message.
UN ABLE TO ACCESS DISK
(CR) TO PROCESS DIFFERENT DEVICE
Press CR to process a. different device.
(CR) - INSTALL'DEADSTART'
MODULE ON DISK
R - RELEASE CMSE- RESERVED
DISK SPACE
Figure 2-24. Install CTI on RMS Display
2-23