..
tp
-3
~
c:n
o
>l:>-
e,.,
c.n
c:n
o
o
t"'
MESSAGE
OUTPUT FILE BAD.
OVERLAY ovl BEING LOADED - TRY LATER
OVERLAY DATA EXCEEDS 22 CHARACTERS
OVERLAY ID ERROR - FIRST CHARACTER INVALID
OVERLAY
ID
ERROR - INVALID CHARACTER
OVERLAY ID ERROR-3 CHARACTER NAME REQUIRED
OVERLAY LOAD ACTIVITY - TRY LATER
OVERLAY ovl LOADED - MUST DROP FIRST
PARAMETER NOT SPECIFIED.
PARAMETER VALUE EXCEEDS 7 CHARACTERS
PARITY ERROR ON DATA RCVD FROM
EXT CHANNEL.
SIGNIFICANCE
System sector of output file is in error;
file is purged.
The network operator entered an OVERLAY,
LOAD command while an overlay was being
loaded.
ovl
3-character identifier of overlay
being loaded
The network operator entered data for an
overlay which exceeded 22 characters.
The network operator entered an overlay
name which was not in the range A
thr~ugh
O.
The network operator entered an overlay
name containing a character which was not in
the range A through 9.
The network operator entered an overlay
name which was not exactly 3 characters.
The network operator entered an OVERLAY
command while an overlay was being loaded
into the NPU.
The network operator tried to load an
overlay without terminating the previous
overlay.
ovl
3-character identifier of overlay
currently loaded
K-display message indicating one of the
following.
For the add, replace, or switch unit
option, the RU parameter was not
specified.
For the replace or switch unit option,
the CU parameter was not specified.
For the switch option, the ES parameter
was not specified.
No parameter values except data strings in
the OVERLAY and MSG commands can be more
than 7 .characters in length.
A parity
e~ror
was detected on
data received from an external
channel.
ACTION
None.
Reenter the command
at a later time.
Correct data and
reente~
command.
Correct overlay name
and reenter command.
Correct overlay name
and reenter command.
Correct overlay name
and reenter command.
Reenter the command
at a later time.
Drop the current overlay
(refer to OVERLAY,DROP
command in section
7)
and reenter the
OVERLAY, LOAD command.
Correct K-display
input and retry.
Correct parameter
and reenter the
command.
Inform site analyst and
customer engineer.
ROUTINE
REC
NS
NS
NS
NS
NS
NS
NS
CONFIG
CS
SCE
Need help?
Do you have a question about the CYBER 170 Series and is the answer not in the manual?