Control Data Corporation CYBER 170 Series Operator's Manual page 209

C)
o
"' "
w
C11
en
o
o
t'"
tp
W
C11
",-j "'-_/
-
~J
MESSAGE
EQxx TRACK LIMIT.
EQxx nn TRACKS FLAWED.
EQxx TRKtrac SYSTEM SECTOR ERROR.
EQxx,UNuu, CHECKING RESERVE.
EQxx,UNuu, UNIT RESERVED.
EQxx -- VALIDATION ERROR ec.
~
"'--j
SIGNIFICANCE
There is insufficient space to allocate a
catalog, permit, or indirect file chain
needed to initialize device xx.
Informative message indicating the number of
tracks that were successfully flawed.
xx EST ordinal of device
IMS could not read the system sector at this
location while performing maintenance on
direct access files.
xx EST ordinal of device
trac Track number of system sector
Informative message indicating that
controller and unit reservations are
being processed for logical unit uu
on equipment xx.
K-display message indicating that logical
unit uu on equipment xx could not be accessed
due to physical unit reservation.
An
error was detected on equipment xx
during mass storage table validation.
ec Error code; may be anyone or a sum
of the following.
1 Error in track count
2 Error in preserved file count
4 Error in permits chain
10 Error in catalog chain
20 Error in indirect chain
PP programs that attempt to access
equipment xx must wait until the
ACTION
form a PFDUMP (full
or partial) for back-
up before purging.
2. Purge the selected
files; the purge
after dump option of
the PFDUMP may be
used.
If
att~mpting
to
initialize a device
on-line, monitor the
E,A. display and wait
for tracks to become
available. Then enter
K.RERUN.
If attempting to
initialize a device
during deadstart,
redeadstart and check
device usage.
None.
Inform site analyst.
None.
Refer to section 8 for
possible action. Inform
site analyst.
Inform site analyst.
\,-
ROUTINE
MSI
IMS
IMS
1MR
MREC
DSD,
1CK
I,
"