Control Data Corporation CYBER 170 Series Operator's Manual page 222

Nos version 1
Table of Contents

Advertisement

-
!
co
C)
Q
~
W
CTI
C)
Q
Q
t"'
ILLEGAL TIME ENTRY
PERIOD REQUIRED
MESSAGE
ILLEGAL USER ACCESS.
ILLEGAL USER ACCESS.
ILLEGAL
lMR
FUNCTION.
IMBEDDED BLANK IN PARAMETER VALUE
IMBEDDED PERIOD IN PARAMETER VALUE
INCORRECT FORMAT FOR EQ ENTRY.
INCORRECT FORMAT FOR MID.
INITIAL TASK NOT IN TASK LIBRARY DIRECTORY.
INITIALIZE BIT NOT SET ON EQxx.
SIGNIFICANCE
The period preceding the minutes was not
entered in an elapsed time or lost time
entry in response to the CYBERLOG display.
CONFIG was called from a nonsystem origin
job or without mass storage subsystem
priority.
The user tried to perform an operation for
which he is not validated.
Possible causes
include attempts to
run a system origin job from nonsystem
origin
access a restricted subsystem without
proper validation
enter an invalid SRU value
use the V carriage control character
without validation
An
illegal function was issued to
lMR.
An
tIDbedded blank was detected in the
command parameter list.
An
imbedded period was detected in the
command parameter list.
K-display message indicating that a syntax
error was made when entering parameters for
the EQ
keywo~d.
K-display message indicating the machine ID
entered is either not two characters or not
alphanumeric.
The task library file does not contain the
initial task (ITASK).
Device with EST ordinal xx is available and
has a good label but cannot be linked to
another device unless initialize status is
set.
ACTION
Reenter the value for
time with a period
preceding the minutes.
None.
Ensure accuracy of
controL statement or
determine proper vali-
dation ·requirements
via LIMITS statement.
Inform site analyst.
Correct parameter list
and reenter command.
Correct parameter list
and reenter command.
Correct and reenter
K-display input.
Correct and reenter
K-display input.
Inform site analyst.
One of the following.
Enter INITIALIZE
command to set
initialize status
for device and then
enter RERUN to
update list (on K
display) of devices
with initialize
status set.
Enter CLEAR to clear
initialize status
for current device.
ROUTINE
CYBRLOG
CONFIG
LFM,
MSI,
NETVAL,
QFSP,
RESEX,
lMA
lMR
CS
CS
MREC
MREC
TAF
MSI

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Table of Contents