Control Data Corporation CYBER 170 Series Operator's Manual page 276

-
t p
....
o
~
C)
o
oJ:>,
c:,..)
C11
C)
o
o
~
MESSAGE
nnn xx DATA BASE FILES NOT ATTACHED.
name DISABLED
divname-mmm ERROR AND nn WARNING MESSAGES
ISSUED.
npu HAS MESSAGE OUTSTANDING
term HAS type STATUS
te rmnam HUNG BY NVF
SIGNIFICANCE
A count (nnn) of the number of data base
(xx) files not attached by a particular data
base procedure file (xxPR) during trans-
action executive
initia1ization~
The local operator attempted to enable or
disable a terminal when the associated line
was disabled, or attempted to send a message
to a disabled terminal.
name Name of disabled element
If mmm is not zero, the indicated number of
fatal diagnostic message errors are
described in the error summary listing
produced by the NDL processor as part of
the listing output file. A nonze~o value
for mmm indicates that any configuration
file created by the job from the named
division does not contain a verification
record. If nn is not zero, the indicated
number of nonfatal diagnostic message errors
are described in the error summary listing.
A nonzero value for nn does not affect the
verification record of any network
definition file created by the job.
The local operator attempted to send a
message to terminals on an NPU before a
previous message had been completed.
npu Name of NPU to which message was
sent-
Informative message sent only to the host
console operator indicating that the
user at the specified terminal has special
operator status. The console operator has
whatever privileges are not currently held
by this or another terminal user.
termnam Termi~al name
type Type of operator privileges
NOP Network operator
LOP - Local operator
NOPLOP Network and local
operator
The operator attempted to enable or disable
terminal termnam for which NVF refused a
logical connection request. The terminal
will remain inaccessible until the line
fails or is disabled.
ACTION
None.
Enable the disabled
element (refer to the
ENABLE command in
section 7) and reenter
the cOIl}mand.
Correct the NDL
statements input and
rerun the job if mmm
is not zero.
Allow time for the
previous message to be
sent to all terminals
and then reenter the
new message.
None.
The local operator can
disable and then
reenable the line but
this action could
disconnect users at
valid terminals on the
ROUTINE
TAF
CS
DAYYES,
NDLLIST
CS
CS
CS