Control Data Corporation CYBER 170 Series Operator's Manual page 243

Nos version 1
Table of Contents

Advertisement

' , ,--
(j)
o
~
(.)
C)1
(j)
o
o
t"4
%
(0
"--_/
",-j
MESSAGE
NO TERMINALS CONNECTED TO THIS APPL
NO TERMINALS DEFINED.
NO 667x MULTIPLEXER.
NONSHARED DEVICE ACTIVE IN DAT.
NOP/NIP NOT ALLOWED TO LOAD D/L OVERLAY
NOT ALL EQUIPMENT SERVICEABLE.
NOT AUXILIARY PACK.
NOT SYSTEM ORIGIN JOB
"'--/
~
SIGNIFICANCE
Informative message given in response to a
request for status of all terminals
connected to an application.
There are no
terminals connected to the application.
A terminal count of zero was determined
during initialization.
Either the multiplexer defined in the
equipment status table (EST) failed to
respond to initializaton status check, or no
multiplexer is on channel.
A nonshared device accessed by another
mainframe (as determined by MID/machine
index) is described in the device access
table with the same family name and device
number as the device being recovered.
Recovery is impossible.
Preceded by message RECOVERY,dtxx, which
indicates the equipment in error.
ACTION
None.
Verify the network
description file using
the VALNET utility
(refer to Installation
Handbook).
Assume any
stimulated or
multip.1exer devices to
be used are on in the
EST.
Inform site analyst or
customer engineer.
Redeadstart with correct
configuration for
equipment in error.
The network .operator attempted to load the
None.
dump/load overlay (overlay name DLO) into
an NPU.
Only the Network Supervisor program
(NS) is allowed to do this.
Number of local batch devices defined in the
Inform site analyst.
system (card readers, card punches, and
line printers) exceeds maximum of 24B .
allowed.
An
attempt was made to define a nonauxiliary
device as a private pack.
Dayfile message indicating that an attempt
was made to initiate CYBERLOG from a job
other
~han
a system origin job.
The job
aborts.
Correct and enter GO.
None.
\
--
ROUTINE
CS
IAFEX,
TELEX
lTD
RMS,
CMS
NS
110
MSI
CYBRLOG
I

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents