-
~
~
C7)
o
~
~
U1
C7)
o
o
t"'
MESSAGE
TEST MODE, NETWORK NOT. USED.
TOO MANY CRAT FILE ENTRIES.
TOO MANY FILES IN TOTAL DATA BASE.
TOO MANY JOURNAL FILES IN xxJ FILE.
TOO MANY PORTS.
TOO MANY TERMINALS.
TOTAL DID NOT RECOVER PROPERLY.
STATUS IS yyyy.
TRACK BUFFER FULL.
SIGNIFICANCE
Informative message indicating that MCS was
started in global test mode.
There are too many error records on the
xxERPF file.
Self-explanatory.
More than three journal files per data base
were specified, causing the transaction sub-
system to abort.
Mo~e
than 512 ports have been defined in the
multiplexer entries of the equipment status
table (EST).
The total number of terminals defined in the
EST and/or the network description files
exceeds the maximum defined by the assembly
variable MAXTT.
An
error status yyyy was returned on a Total
FINAL call.
Refer to Diagnostics in the
Total Reference Manual for yyyy.
Operator message indicating too many
reserved track entries in CMRDECK.
No more
entries will be accepted.
ACTION
being used, the network
file is NCTFid.
If TAF
interfacing with TELEX
is being used, the
network file is NETWid
if TAF/TS can attach it;
otherwise, TAF/TS uses
SIMFid.
For the TELEX
interface, reinitialize
TELEX and TAF.
For the
NAM interface,
reinitialize TAF.
None.
Inform site analyst.
The bad areas on disk
should be flawed and the
data base reloaded.
Reduce the number of
entries in the TDBID
file or increase
TMAXFIL.
Examine xxJ file for
xxJOR entries. Consult
the TAF data base
administrator.
Inform site analyst.
Reduce the number of
devices in the EST which
are on; verify the
network description file
using the VALNET
utility (refer to the
NOS Installation
Handbook).
Correct error and
reinitialize transaction
executive.
Inform site analyst.
ROUTINE
MCS
TAF
TAF
TAF
lTD
IAFEX,
TELEX
TAF,
TAFNAM2,
TAFTS2
SET
Need help?
Do you have a question about the CYBER 170 Series and is the answer not in the manual?