Elapsed Time Entries; Cyberlog Display Request For Elapsed - Control Data Corporation CYBER 170 Series Operator's Manual

)
)
",
If the reason for an unscheduled event is communication,
the following display (figure 2-31) appears.
Enter the code for the component causing the
communications failure. The item you enter appears on the
line labeled COMPONENT.
ELAPSED TIME ENTRIES
The time that the event had an effect on the system is
recorded as elapsed time. The request for elapsed time
appears for both scheduled and unscheduled events. Figure.
CYBERLOG
EVENT TYPE: UNSCHEDULED
REASON: COMMUNICATIONS
2-32 illustrates a sample display showing the request for
elapsed time.
Enter the elapsed time in hours and minutes in the format
shown. The range of values for hours is 0 through 99 and
the range of values for minutes is 00 through 59. A leading
zero is not required for hours, but two digits are required
for the minutes entry. A period is required to delimit the
hours from the minutes. The time you enter appears on the
line labeled ELAPSED TIME.
For scheduled events, the lost time and impact do not
apply. The lost time field is set to 00.00. The impact field
is blank.
ENTER THE CODE FOR THE COMPONENT CAUSING FAILURE
CODE
o
1
2
3
4
5
6
DESCRIPTION
OTHER
SUBSYSTEM HARDWARE
HOST SOFTWARE
LINE ADAPTER
MODEM
SUBSYSTEM SOFTWARE
UNKNOWN
Figure 2-31. CYBERLOG Display for an Unscheduled Event Caused by Communications
) CYBERLOG
60435600 J
EVENT TYPE: UNSCHEDULED
REASON: HARDWARE
COMPONENT: DISK SUBSYSTEM
ENTER THE ELAPSED TIME SINCE THE SYSTEM WAS FULLY OPERATIONAL
IN THE FORM
HH.MM
Figure 2-32. CYBERLOG Display Request for Elapsed Time
2-31