Control Data Corporation CYBER 170 Series Operator's Manual page 277

'-
0)
o
~
w
U1
0)
o
o
t"'I
cp ....
o
w
-
"' - --
--,'
"--
MESSAGE
name IN RECOVERY
name INOPERATIVE
ss INPUT CARD ERROR ec
"---/'
"' - --
SIGNIFICANCE
The local operator attempted to enable or
disable a line or terminal on an NPU whose
configuration is currently being recovered.
This message may also be given in response
to status requests during recovery. If
name is that of an NPU, the list of line
status messages preceding this message will
be incomplete. If name is that of a line,
the list of terminal status messages
preceding this message wll be incomplete.
The local operator attempted to send a
message to a terminal (name) that is
currently inoperative.
An
error was detected while processing
default file directives on the file INPUT.
This message is followed by a card image of
the directive found to be in error. The
default being defined by the directive is
ignored.
ss Supervisor job containing the
directive in error (CS or NS)
ec Error code
1 Illegal command
2 TSB request rejected
3 Extra command parameter
4 Invalid parameter
5 Input record greater than 50
characters
6 Imbedded period
7 Imbedded blank
8
9
Parameter greater than 7
characters
Duplicate NCF input card (NS
only)
10 No PFN on input card
11 ·Duplicate LCF input card (CS
only)
12
Duplicate CCP input card (NS
only)
13 Maximum number of input cards
exceeded 10 (NS only)
ACTION
line. If all terminals
on a line reach this
inaccessible state, the
line is automatically
disconnected (dial-up)
or disabled (hard-
wired).
Enter command at
a later time.
Wait for the terminal
status message (TERM
name, ••• ) indicating the
terminal is operational
and reenter the command.
The NS or CS job
initiated by the NAM
procedure file at
initialization must be
corrected.
"----
ROUTINE
CS
CS
NS,
CS
\"",-
_
..
'