Control Data Corporation CYBER 170 Series Operator's Manual page 244

~
o
(J)
o
~
~
c.n
(J)
o
o
t"'4
MESSAGE
NP GREATER THAN 8.
NP NOT ALLOWED.
NPU: npu,status,node
NPU npu/O/L SEQ. PREEMPTED FOR DLO
NPUnpu - OVDAT/DATA/SM ERROR INVALID
PORT=prt OR SUBPORT=spt
NPU npu/OVERLAY ovl LOADED
NPU npu/OVERLAY ovl NOT LOADED, RC=ec
SIGNIFICANCE
Number of packs specified for multispindle
device cannot exceed eight.
The NP parameter (number of packs) was
specified and the device to be initialized
is not a pack type device.
NPU status message sent in response to a
STATUS command, or when a significant change
in status has occurred.
npu Name of NPU
status Status of NPU
DI Disabled
EN Enabled
AC Active
DN Down
node Node number
Because of a remote NPU failure, the load
of a diagnostic overlay was terminated so a
dump/load overlay could be loaded.
NS received a dump/load sequence supervisory
message concerning a connection which is not
being used for dumping or loading. A
possible cause for this is an improperly
built CCP file.
npu Name of NPU
prt 3-character identifier of port
spt 3-character identifier of subport
The overlay has been loaded in the NPU.
npu Name of the NPU
ovl 3-character identifier of overlay
An
attempt to load an overlay was
unsuccessful.
npu Name of the NPU
ovl 3-character identifier of overlay
ec Error code
1 Checksum error on load detected
2
Unrecognizable overlay ID
3 NPU disabled
4 Priority overlay active
5 NPU off
6 . Overlay active
7 Overlay load in progress
8
Load pre-empted by dump/load
9
NPU failed during load
10 Time for NPU response expired
ACTION
Enter correct number of
packs and then enter GO.
Correct and enter GO.
No action required if
response to STATUS
command. Check dayfile
for
su~sequent
messages
Which might indicate a
change in status.
None. The diagnostic
overlay can be loaded
after the NPU is
loaded.
Verify CCP file.
None.
None.
ROUTINE
MSI
MSI
NS
I
NS
NS
NS
NS