Control Data Corporation CYBER 170 Series Operator's Manual page 261

",--/J '"
0)
c
~
~
U1
0)
C
c
t""
~
..;J
-
",-,
MESSAGE
SR-m-2 yyyy yyyy yyyy yyyy yyyy.
SR-m-l yyyy yyyy yyyy yyyy yyyy yyyy.
SR-m-O yyyy yyyy yyyy yyyy yyyy yyyy.
STxx, FNff, FUNCTION TIMEOUT.
STxx, INCOMPLETE TRANSFER.
STAGING DELAY, DISK FULL.
FMafamname, UI=userin.
REPLY GO TO CONTINUE
STRING TOO LONG.
SUBSYSTEM ABORTED.
SUP xx.
"--->
"' -
SIGNIFICANCE
A status/control register error has been
detected. Error log message.
m Channel register
o
Channel 16 register
1 Channel 36 register (if 20
PPUs are being used; in this
case the contents of both
registers are given)
yyy ••• yyy Contents in octal of words 16
through 0 as specified below.
SR-m-2 words 16-12 (bits 203-
144)
SR-m-l words 11-6 (bits 143-72)
SR-m-O words 5-0 (bits 71-0)
Dayfile and error log message indicating
that the driver (lED) issued a function to
the multiplexer and did not receive an
inactive signal within four major cycles.
This error causes the subsystem to abort.
xx EST ordinal of multiplexer
ff Function
Dayfile and error log message indicating
that the driver (lED) was unable to transfer
the expected amount of data during an input
or output operation. This error causes the
subsystem to abort.
xx EST ordinal of multiplexer
K-display message indicating that there is
not enough space on the disk during an
attempt to stage a file for user index
userin on family famname from MSF to disk.
The stage attempt repeats after a delay,
allowing you time to free enough space for
the file to be copied to disk.
CFO command contains a string longer than
seven characters.
The user job was connected (either long
term connection or wait response set) to a
subsystem which aborted.
System· dayfile message indicating that the
operator requested automatic printer
carriage control suppression on BATCHIO
equipment xx.
ACTION
Inform customer engineer.
Inform customer
engineer.
Inform customer
engineer.
Contact a site analyst
to run the ASMOVE
utility to make disk
space available. Enter
K.m.GO to clear the
message.
m Message ordinal
Reenter .the command.
Re try la ter •
None.
"-- \.
ROUTINE
1MB
lED
lED
EXSTGE
MCS
lAJ
QAP