Control Data Corporation CYBER 170 Series Operator's Manual page 196

-
~
to.:)
en
o
~
Coo)
U1
en
o
o
t"'
MESSAGE
DJ •••
DK •••
DKxx, NO FT CONTROLLER.
DKxx, 2X PPU REQUIRED.
DL •••
DLxx, NO FT CONTROLLER.
DLxx,
2X
PPU REQUIRED.
DM •••
DN CANNOT BE ZERO.
SIGNIFICANCE
serialn Pack serial number
Refer to description of the corresponding
message beginning with DI or EQ.
Refer to.description of the corresponding
message beginning with DI or EQ.
The equipment with EST ordinal xx has been
defined as a full track 844-21 disk but
there is no 7154 full track controller
present.
The equipment with EST ordinal xx requires
2X PPUs but 2X PPUs do not exist.
Refer to description of corresponding
message beginning with DI or EQ.
The equipment with EST ordinal xx has been
defined as a full track 844-41/44 disk but
there is no 7154 full track controller
present.
The equipment with EST ordinal xx requires
?X PPUs but 2X PPUs do not exist.
Refer to description of corresponding
message. beginning with DI or EQ.
DN=O was entered to clear a duplicate device
number error. The device number (DN) cannot
be zero for a family type device.
ACTION
If a full track
controller is not
present, redefine the
device as a half track
device. If a full track
controller is actually
present but not
detected, ensure the
correct controlware is
specified on the LBC
CMRDECK entry.
Enable 2X PPUs or
redefine the device as a
half track device.
I f
a full track
controller is not
present, redefine the
device as a half track
device. If a full track
controller is actually
present but not
detected, ensure the
correct controlware is
specified on the LBC
CMRDECK entry.
Enable 2X PPUs or
redefine the device as
a half track device.
Enter a nonzero value to
continue or enter GO to
override the error.
ROUTINE
STL,
BCL
STL,
BCL
STL,
BCL
STL,
BCL
MSI