Time - Control Data Corporation CYBER 170 Series Operator's Manual

"--~J "-~~
CJ)
Q
~
c,..)
c:J1
CJ)
Q
o
t'"
tl'l
I
c,..)
1-6
-
"-~j
MESSAGE
EQxx EQyy CONFLICTING DN.
EQxx EQyy CONFLICTING PN.
EQxx EQyy CONFLICTING UM.
EQxx,FEED FAILURE.
EQxx FLAWING INCOMPLETE.
EQxx nn FLAWS NOT PROCESSED, list.
"'-~ "-~~
SIGNIFICANCE
deadstart or when a removable device is
introduced into the system.
Two devices in the same family- have the same
device number and the system library resides
on one of them. xx and yy are the EST
ordinals of these devices. Recovery is im-
possible~
This message is preceded by the message
RECOVERY, dtxx. Which indicates the equip-
ment that is in error.
Two auxiliary devices have the same pack
name and the system library resides on one
of them. xx and yy are the EST ordinals of
these devices. Recovery is impossible.
This message is preceded by the message
RECOVERY, dtxx. which indicates the equip-
ment that is in error.
Two devices in the same family have the same
bits set in the device mask, and the system
library resides on one of them. xx and yy
are the EST ordinals of these devices.
Recovery is impossible.
This message is preceded by the message
RECOVERY, dtxx. which indicates the equip-
ment that is in error.
A card feed problem was detected.
Flaw map could not be read during
initialization. For multiunit 844
equipment, some flaws may not have been
recorded.
Informative message indicating the number of
flaw entries not processed because the
tracks specified (list) were in use.
xx EST ordinal of device
ACTION
Inform site analyst;
recommended action is
one of the following.
- Remove one of the
specified devices
and redeadstart.
- Redeadstart and
logically turn off
one of the specified
devices (via CMRDECK
entry).
Inform site analyst;
recommended action is
one of the following.
Remove one of the
specified devices
and redeadstart.
Redeadstart and
logically turn off
one of the specified
devices (via CMRDECK
entry).
Inform site analyst;
recommended action is
one of the following.
Remove one of the
specified devices
and redeadstart.
Redeadstart and
logically turn off
one of the specified
devices (via CMRDECK
entry).
Contact customer
engineer.
Reformat 881 or 883
packs.
Reenter list of tracks
to be flawed at a later
time.
\
ROUTINE
RMS
RMS
RMS
QAP
IMS
IMS
\
\,---