Control Data Corporation CYBER 170 Series Operator's Manual page 253

C')
I:)
~
~
c:n
C')
o
I:)
t"'
%
CO
-
\. I
\,
"--
MESSAGE
QF LENGTH ERROR filename
QFM ERROR ec RETURNED ON TASK SUBMIT.
RANDOM ADDRESS ERROR.
RBF DISK ERROR, CANNOT REDUCE SIZE.
RBF ENDED.
RBF NOT ENABLED.
RBF NOT STARTED PROPERLY, USE N.RBF.
~/
",,-
_/
SIGNIFICANCE
than MXPS.
Parameter block was not in the field
length.
Complete bit was not cleared on the
call.
Function code was invalid.
Parameter block was less than seven
words long.
Interlock data in system sector of queued
file indicates that the last sector of the
file (specified by TRT) was not an EOI
sector.
filenam Name of file on which error was
encountered
QFM has informed the transaction subsystem
that an error other than a job or user
statement error was detected.
ec QFM error
Dayfile message indicating that an error was
encountered while building the system
library. The random address is not on file.
Because of a disk error, RBF cannot perform
periodic field length reduction. RBF
processing is unaffected, but CM usage is
higher than normal.
Informative message indicating that RBF has
terminated.
RBF attempted to enter the network but was
rejected because it was disabled by the
local operator.
An
attempt was made to initiate RBF
incorrectly, such as with an X.RBF command.
ACTION
error.
Inform site analyst.
On a l'evel 3 recovery,
the system sets error
idle status for the
device. On a level 0
recovery, enter n.DROP
to set error idle
status for the device.
Enter n.GO to continue
recovery.
Inform site analyst.
Attempt another
deadstart. If the error
persists and the system
has worked previously,
call a customer engineer
and test memory and RMS.
To lower CM usage by
RBF, idle down RBF and
restart.
None.
Enable RBF and retry
the operation.
Initiate RBF with the
n.RBF command (refer to
section 3). The copy
of RBF started
incorrectly is dropped
automatically.
\"-
\.
ROUTINE
REC
TAF
SLL
RBF
RBF
RBF
RBF