tp
CTI
Q
CD
Q
~
~
CTI
CD
Q
Q
1:"4
MESSAGE
INVALID CONTROL CARD OPTION.
INVALID PROGRAM NUMBER.
10 ERROR ec ON filename
10 ERROR ec ON ROLLOUT.
IPL NOT FOUND
ISD ERROR, vvvvv.
REPLY GO TO RETRY - DROP TO OFF DEVICE.
ISF COMPLETE.
JOB RERUN.
JOB(S) HUNG.
JOBS HUNG IN SYSTEM.
SIGNIFICANCE
The NDLP control statement used by the job
contains a format or syntax error.
The CTI module has requested the loading of
an undefined module.
A CIO error ec was encountered on file
filename
Because of 10 errors, the MCS subsystem
could not rollout.
cc
CIO error code (refer to the NOS
Reference Manual, volume 2)
The initial program loader in CTI was not
found.
K-display message indicating that an input
or output (vvvvv) belt malfunction occurred
on the mass storage transport.
Dayfile message indicating that ISF opera-
tion is complete.
Informative message indicating that the job
was terminated and the input file requeued.
Informative message indicating that
time-sharing subsystem has encountered some
time-sharing origin (TXOT) jobs at control
points and is attempting to roll them out.
This message is displayed only for a short
period of time.
Jobs of TXOT origin were. found in the
system during initialization.
These jobs
must be removed before IAF can be
initialized.
ACTION
Correct the statement
and rerun the job.
Redeadstart.
If the
message persists, contact
customer engineer.
Refer to the message
following this message
for the disposition of
the file.
None.
Redeadstart.
Verify that the
cartridges are
aligned correctly on
the input or output
belt and enter K.m.GO.
If any cartridge is
not aligned, enter
K.m.DROP and call a
customer engineer.
m Message ordinal
None.
None.
None.
Inform site analyst.
ROUTINE
-------
NDLMAIN
DHE
MCS
MCS
ICD
MSSEXEC
ISF
lCJ
IAFEX,
TELEX
IAFEX
I
Need help?
Do you have a question about the CYBER 170 Series and is the answer not in the manual?