Control Data Corporation CYBER 170 Series Operator's Manual page 216

-
t p
~
t.:I
Q)
o
~
~
c.n
Q)
o
o
t"'I
MESSAGE
FILE TYPE MUST BE IS OR DA.
FIRMWARE LOAD, PART NO. - 12345678.
FM OR PN MUST BE SPECIFIED.
FORCED SHUTDOWN REQUESTED.
FORMAT ERROR.
FORMAT ERROR IN TERMINAL DESCRIPTION FILE.
FORMAT ERROR IN THE NETWORK DESCRIPTION FILE.
FORMAT UNIT FUNCTION REJECTED.
FROM npu/ovl ••• message
FROM t ermnam:
message
FROM npu/RES ••• message
FULL INITIALIZE REQUIRED.
SIGNIFICANCE
The type parameter on the CRM statement must
be either IS· (indexed sequential) or DA
(direct access).
Informative message indicating that
magnetic tape controller controlware has
been loaded.
Family or pack name must be entered to
initialize device.
RBF has stopped communications with the
network and is performing clean-up
operations.
K-display message indicating that an error
exists in the syntax of the command or the
values of the parameters.
Statements on the NETWid file are in error.
During transaction executive initialization,
one or more errors were found to exist in
the network description file.
An
alternate deadstart to a 67x tape unit
is impossible.
An
NPU overlay has sent a message
to the network operator.
A terminal user has sent a message to the
local operator.
termnam Name of terminal
The resident code in an NPU (not an overlay)
has sent an alarm message to the network
operator.
Operator message indicating an error
was encountered and a total initialize
is required on the pending device.
ACTION
Correct the type
parameter on the CRM
statement or inform
site analyst.
None.
Enter the required family
name or pack name,
and then enter GO.
No action required.
RBF will be dropped
automatically when
clean-up operations are
complete.
Correct the command or
parameters and retry
operation.
Run VALNET on NETWid.
Cor;ect indicated
errors. Reinitialize
transaction subsystem.
Inform site analyst.
Redeadstart.
Respond according to the
message.
Respond according to the
message.
Respond according to the
message.
Specify AL initializa-
tion option (total
initialize) on
the INITIALIZE
command.
ROUTINE
TAF
1MT
MSI
RBF
TAF,
PFLOAD,
STIMULA
TAF
TAF
SAD
NS
CS
NS
MSI