Control Data Corporation CYBER 170 Series Operator's Manual page 242

Nos version 1
Table of Contents

Advertisement

-
t p
0)
00
C)
o
,::..
c;..,)
C11
0)
o
o
t"'
MESSAGE
NO INITIALIZE REQUESTS SET FOR MSI.
NO JOBS IN SYSTEM.
NO LINES CONFIGURED ON THIS NPU
NO LINK DEVICE DEFINED.
NO OVERLAY LOADED/ACTIVE
NO SHARED DEVICES FOR THIS MACHINE.
NO SYSTEM DEVICE DEFINED.
NO TAPE EQUIPMENT.
NO TERMINALS CONFIGURED ON THIS LINE
SIGNIFICANCE
MSI was called by some means other than the
INITIALIZE command (for example, X.MSI.),
and initialize status is not currently set
for any mass storage devices.
Informative message indicating that the
time-sharing subsystem has successfully
deactivated all terminal-originated
activities that were in the system.
The NPU specified in the status message
immediately preceding this message has no
configured lines.
This message may be given
in reponse to a request for status of all
lines or all terminals on the
net~ork
or a
specific NPU.
Operator message indicating that a link
device (ECS) was not identified in CMRDECK
during an attempt to deadstart into
a multimainframe environment.
The network operator tried to send data to
an overlay or terminate an overlay When
there were none active.
The machine on which MREC is being run is
not in multimainframe mode; therefore, it
cannot access any devices on an inoperative
machine.
Operator message indicating that the mass
storage device on which the system is to be
loaded has not been defined.
There is no magnetic tape equipment
currently defined in the system.
The line specified in the status message
immediately preceding this message has no
configured terminals.
This message may be
given in response to a request for status of
a single terminal or all terminals connected
to a line, an NPU, or the network.
ACTION
None.
None.
None.
Redeadstart and identify
the link device with
LINK=xx. command.
None.
None.
Define the system device
with the SYSTEM=n.
command or redeadstart
and specify a system
device with bits 0
through
5
of word
14
on
the deadstart panel.
Inform site analyst.
None.
ROUTINE
MSI
IAFEX,
TELEX
CS
SET
NS
MREC
SET,
ICM
1MT
CS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Table of Contents