Control Data Corporation CYBER 170 Series Operator's Manual page 184

-
t :tI
~
o
Q)
o
~
Co)
c.n
Q)
o
o
t"'4
MESSAGE
CCP VERSION 3.1 ,LEVEL nnnn,VAR mmmm
CE DIAGNOSTICS IN PROGRESS
CRcc MAaaa - Ann.
CRcc, Unuu - Szzzz.
CHANGED LIBRARY FILE DETECTED.
CHANNEL cc PARITY ERROR.
CRECK *E,P* DISPLAY.
SIGNIFICANCE
follows the original message, the current
CCP file cannot be used for NPU loads.
fi1enam Name of CCP load file
usernam User name under which CCP load
file is stored
Informative message sent to the network
operator following a successful NPU load
indicating the version, level, and variant
of the CCP software loaded in the NPU.
nnnn Level of CCP software
mmmm Variant of CCP software
A customer engineer is currently running
diagnostics on the line which was specified
in the status message immediately preceding
this diagnostic.
Informative message indicating the
controlware name and revision number for a
7054, 7154, or 7155 mass storage controller.
cc Channel number
aaa Type of controlware
710 7054/7154 controlware
401 7154 controlware
721 7155 controlware
nn Controlware revision number in octal
Operator message indicating the status
zzzz of unit uu on deadstart channel cc.
This message is significant only if the
deadstart process halts.
An unrecognizable library directory format
was encountered during a library directory
update attempt.
A parity error was detected on channel cc.
An error condition or request for operator
action is currently being displayed on the
E,P display. Operator action is required.
ACTION
None.
No action is required.
The local operator can
attempt to enable the
line at a later time.
None.
If hardware malfunction
is suspected, inform
customer engineer.
Otherwise, try a
different deadstart tape
or disk unit.
Inform site analyst.
Inform site analyst and
customer engineer.
Bring E,P display to
console screen and
perform necessary
action. (See status
field of E,P display,
section 4.)
ROUTINE
NS
CS
OCI
DIO
TAF
SCE
1MT