Control Data Corporation CYBER 170 Series Operator's Manual page 190

Nos version 1
Table of Contents

Advertisement

to
I
....
en
en
c
~
~
U1
en
c
c
t"'4
MESSAGE
CS FAILURE.
CSxx,MSID ide
CSM' - ILLEGAL COMMUNICATION FUNCTION.
esu
x
ADDRESS PARITY ERROR.
CSU EST ERROR xx.
pfn FOR jobname NOT FOUND ON MSF.
REPLY GO TO CONTINUE.
CSU x FAULT.
CSU id INPUT DRAWER EMPTY.
CSU id INPUT DRAWER d EMPTY.
SIGNIFICANCE
The Communication Supervisor (CS) has
aborted.
NAM takes an internal dump and
terminates.
K-display message indicating that there is
an error condition on the cartridge storage
unit.
xx
EST ordirial
id
Cartridge storage unit identifier
An
illegal or unrecognizable request was
received by the transaction executive from
the CPU monitor.
A central storage unit (eSU) address
parity error was detected on CSU x.
x
CSU number (0 or 1)
K-display message indicating that an error
was detected on a cartridge label from the
cartridge storage unit with EST ordinal xx.
A probable cause of this error is entering
the wrong identifier on the EST entry for
the cartridge storage unit.
pfn
Permanent file name
jobname
Job name
A central storage unit (CSU) hardware
error was detected on CSU x.
x
CSU number (0 or 1)
A cartridge is needed from the input drawer
of the cartridge storage unit (CSU id) to
process the directive to ASLABEL or ASDEBUG.
id
CSU identifier (A through M)
A cartridge is needed from slot d of the
input drawer of the cartridge storage unit
(CSU id) to process the directive to
ASLABEL.or ASDEBUG.
id
CSU identifier (A through M)
ACTION
Reinitialize NAM.
Supply dumps to site
analyst.
Refer to the message(s)
following this message
for appropriate action.
Inform site analyst.
Inform site analyst and
customer engineer.
(For
further explanation and
procedures, refer to
sIc
Register Error
Detection, Appendix F.)
Enter K.m.GO to clear
the message.
m Message ordinal
Inform site analyst and
customer engineer.
(For
further explanation and
procedures, refer to
sIc
Register Error
Detection, Appendix F.)
Put the required
cartridge into the
input drawer.
Put the required
cartridge into the
input drawer slot.
ROUTINE
NIP
MSSEXEC
TAF
SCE
EXSTGE
SCE
ASLABEL,
ASDEBUG
ASLABEL,
ASDEBUG
I

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents