Control Data Corporation CYBER 170 Series Operator's Manual page 254

Nos version 1
Table of Contents

Advertisement

-
~
CI
CD
CI
~
Co)
c.n
CD
CI
CI
t"'4
MESSAGE
RDM ARGUMENT ERROR.
RDM ILLEGAL REQUEST.
READ PYRAMID PARITY ERROR.
REASSIGN ADL.
RECONFIGURATION NOT POSSIBLE.
RECONFIGURATION UTILITY COMPLETE.
RECORD NOT FOUND.
RECOVERING EQxx Annnn.
RECOVERING PF EQxx, TRKnnnn.
RECOVERY, dtxx.
RECOVERY COMPLETE.
SIGNIFICANCE
Illegal function code or status word
address out of range was encountered.
The calling job did not have mass storage
subsystem queue priority or auto recall was
not set •.
A parity error was detected in a
read pyr amid.
Informative message.
On-line switching or replacing of units is
not possible according to the current system
configuration (EST ordinal 0 is not RD
type).
Informative message indicating that all
equipment with redefinition requests has
been processed.
Error was encountered during the building of
the system library.
An attempt was made to
place a nonexistent routine on an alternate
system device.
Deadstart processing halts
when this error is detected.
Informative message indicating that direct
access files on the specified logical track
of mass storage device xx are being
recovered.
xx
EST ordinal of device
nnnn Logical track number
Informative message indicating that
preserved files on the specified logical
track of device xx are being recovered.
xx
EST ordinal of device
nnnn Logical track number
Informative
messag~
indicating mass storage
device being recovered during sys·tem
deadstart.
dt
Device type
xx
EST ordinal of device
Informativ~
message indicating that a level
3 recovery deadstart was successful and the
magnetic tape subsystem was recovered.
ACTION
Inform site analyst.
Inform site
a~alyst.
Inform site analyst and
customer engineer.
Enter
~.CFO.ADL
command.
Inform site analyst;
deadstart may be
required.
None.
Attempt another dead-
start.
If the error
persists, inform the
site analyst.
None.
None.
None.
None.
ROUTINE
RDM
RDM
SCE
MCS
CONFIG
CONFIG
SYSEDIT
REC
tMR
RMS
MAGNET

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CYBER 170 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents